Pach and Company AeGIS 7000 Series Manual - Manual (Page 15)

2) MULTI-SYSTEM IN SINGLE TELEPHONE LINE
Step 1 Call into the AeGIS 7000 using a touch tone phone. When the system answer you will hear:
• One Short Beep: Door is opened.
• Two Short Beeps: Door is closed.
• One Long Beep: Combination of Closed and open.
Step 2 Press the System Number you want to log in (1-8) then press # key.
Step 3 Press your valid Master Code.
• If your Master Code is accepted, you will hear Two Short Beeps and you are in the programming mode,
then proceed to Touch Tone Programming Table 3.1.
Note: If the system idles in 30 seconds, the display will return to a scrolling mode.
• If your Master Code is rejected, the system will disconnect.
Step 4 Follow the next programming sections below to program the tenant database and parameters.
TABLE 3.1 PROGRAMMING FUNCTION CODES
*
#
00
REPLACE SYSTEM
MASTER CODE
(Default setting is
0000)
Master Code is used to log
on to programming mode,
not to unlock door or gate.
1. Exit the programming mode by pressing * once or
twice.
2. Clear the programmed name, phone number or access
code by pressing *
3. Press * then the 4-digit access code to unlock the door
or gate via the system keypad.
Press # to accept program.
Step 1 Log on to programming mode (see section 3.1).
The display shows
Step 2 Enter Function code 00, then press #, the display
shows
Step 3 Enter the new 4-digit Master Code then press #
the display shows
If you press * the display shows
Ignore the message, and your existing Master
Code will remain in the system.
Step 4 Select another Function Code to program
different field from the table or press * to exit the
programming mode and you hear “Three
Short Beeps”.
NOT APPLICABLE.
IF PURCHASE 2004
AND AFTER.
Press # to accept program.
Step 1 Log on to programming mode,
see section 3.2. If you have
logged on. Proceed to step
2.
Step 2 Enter Function Code 00 and
press #, you will hear “One
Short Beep”.
Step 3 Enter the new Master Code and
press #, and you will hear “Two
Short Beeps”.
Step 4 Select another Function Code to
program another parameter or
press 91 then press # to
disconnect the call, you will hear
“Three Short Beeps”.
FUNCTION CODE LOCAL PROGRAMMING TOUCH TONE PROGRAMMING
Pach and Company Chapter 3 Page 8
AeGIS 7000 Series PROGRAMMING
Select Func: _ _
Master Code: 0000
Select Func: _ _
ERROR DATA * * * *