Pach and Company AeGIS 7000 Series Manual - Manual (Page 18)

Pach and Company Chapter 3 Page 11
AeGIS 7000 Series PROGRAMMING
03
DELETE AN
EXISTING TENANT
DIRECTORY
Delete an existing tenant
one by one. This function
code is very useful to free
the system memory by
deleting the unused
directory.
04
CLEAR ALL
TENANTS
DIRECTORY
Step 5 • To change phone number: press * to erase
and program a new one then press #.
• To keep the phone number: press #.
The display shows:
X is existing access code.
• To change access number: enter a new one
then press #.
• To keep the access code: press #.
Step 6 Proceed to step 2 and select the same Function
Code or different Function Code to continue
programming or press * to exit the programming
mode and you will “Three Short Beeps”.
Step 1 Log on to programming mode (see section 3.1),
the display shows:
Step 2 Enter Function Code 03 then press #, the
display shows:
Step 3 Enter a tenant directory code you want to delete
the press #. The display shows:
If the directory does not exist, the display shows:
Proceed to step 2.
Step 4 Proceed to step 2 and select the same Function
Code or different Function Code to continue
programming or press * to exit the programming
mode and you will hear “Three Short Beeps”.
Step 1 Log on to programming mode (see section 3.1),
the display shows:
Step 2 Enter Function Code 04 then press #, the
display shows:
Step 3 • Press 13 then # the display shows:
then proceed to step 4 or
Step 1 Log on to programming mode,
see section 3.2 If you have
logged on proceed to step 2.
Step 2 Enter Function Code 03 then
press #, you hear “One Short
Beep”.
Step 3 Enter the tenant directory code
(2, 3 or 4 digits) you want to
delete then press # and you hear
“Two Short Beeps” means
directory is deleted or “One Long
Beep” then “Two Short Beeps”
means vice versa.
Step 4 Select another Function Code to
program another parameter or
tenant's directory, otherwise enter
91 then press # to disconnect the
call, you hear “Three Short
Beeps”.
NOT AVAILABLE.
FUNCTION CODE LOCAL PROGRAMMING TOUCH TONE PROGRAMMING
Access Code: X X X X
Select Func: _ _
Delete Dir: _ _ _
(Dir Code) is deleted !
Error on Delete !
Select Func: _ _
Delete all? 13
Are you sure ? 5