Pach and Company AeGIS 7000 Series Manual - Manual (Page 22)

70
CHANGE TALK
TIME
(Default setting is
60
seconds)
The talk time is the length
of time the visitor can talk
to the tenant. The talk time
timer starts as soon as the
system initiates the call.
71
CHANGE DOOR
OPEN INTERVAL
(Default setting is
12 seconds)
The Door Open Interval is
the length of time the
relay turns on.
72
CHANGE LOCK
OUT COUNT
(Default setting is
3)
The system is disabled if
invalid access code has
been entered according to
the lock out count sets on
Function Code 72. The
system will ignore further
access code entries for 90
seconds.
to continue programming or press * to exit the
programming mode and you will hear “Three
Short Beeps”.
Step 1 Log on to programming mode (see section 3.1),
the display shows:
Step 2 Enter Function Code 70 then press #, the
display shows:
Step 3 Enter Talk Time Value in 3-digit mode (010 -
180) seconds the press #.
Step4 Press * then proceed to step 2 and select the
same Function Code or different Function Code
to continue programming or press * to exit the
programming mode and you will hear “Three
Short Beeps”.
Step 1 Log on to programming mode (see section 3.1),
the display shows:
Step 2 Enter Function Code 71 then press #, the
display shows:
Step 3 Enter the Open Time value in 2-digit mode (04-
99) seconds then press #.
Step4 Press * then proceed to step 2 and select the
same Function Code or different Function Code
to continue programming or press * to exit the
programming mode and you will hear “Three
Short Beeps”.
Step 1 Log on to programming mode (see section 3.1),
the display shows:
Step 2 Enter Function Code 72 then press #, the
display shows:
Step 3 Enter the lock out count in one-digit mode (1-9).
Step4 Press * then proceed to step 2 and select the
Step 1 Log on to programming mode,
see section 3.2 If you have
logged on proceed to step 2.
Step 2 Enter Function Code 70 then
press #, you hear “One Short
Beep”.
Step 3 Enter the talk time in 3-digit mode
(10-180 seconds) and press #
and you will hear “ Two Short
Beeps”.
Step 4 Select another Function Code to
program another parameter or
tenant's directory, otherwise enter
91 then press # to disconnect the
call, you hear “Three Short
Beeps”.
Step 1 Log on to programming mode,
see section 3.2 If you have
logged on proceed to step 2.
Step 2 Enter Function Code 71 then
press #, you hear “One Short
Beep”.
Step 3 Enter the Open Time value in 2-
digit mode (04-99) seconds then
press # and you will hear “ Two
Short Beeps”.
Step 4 Select another Function Code to
program another parameter or
tenant's directory, otherwise enter
91 then press # to disconnect the
call, you hear “Three Short
Beeps”.
Step 1 Log on to programming mode,
see section 3.2 If you have
logged on proceed to step 2.
Step 2 Enter Function Code 72 then
press #, you hear “One Short
Beep”.
Step 3 Enter the Lock Out Count value in
one-digit (04-99) seconds then
press # and you will hear “ Two
Short Beeps”.
Step 4 Select another Function Code to
FUNCTION CODE LOCAL PROGRAMMING TOUCH TONE PROGRAMMING
Pach and Company Chapter 3 Page 15
AeGIS 7000 Series PROGRAMMING
Select Func: _ _
TALK TIME: 060
Select Func: _ _
OPEN TIME: 12
Select Func: _ _
LOCK-OUT CNT: 3