Bosch THD2023 Heißwasserspender Filtrino FastCup - Manual (Page 17)

17
THD20.. 07/2011
en
Display elements
L
On this setting, room-tempera-
ture water will be supplied.
70 °C
80 °C
90 °C
With the 70 °C, 80 °C and 90 °C
settings, the water will be heated
to the selected temperature.
Examples
70 °C – for white tea
80 °C – for green tea
90 °C – for instant beverages
such as hot chocolate or coffee
Note: The temperatures at the
water outlet can vary by approxi-
mately ± 5% .
At this setting, the water will be
boiled. This setting is suitable,
for example, for black tea or
instant soups.
M
When the M icon lights up, the
BRITA MAXTRA ilter cartridge
should be replaced. You can
continue to heat water. For
information about replacing the
water ilter cartridge, see the
section titled “BRITA MAXTRA
water ilter system”.
After changing the ilter, hold
down the start/stop button for
at least 5 seconds, M will cease
to light.
O
The O icon lights up when the
water tank needs to be reilled
or is missing. Remove the
water tank, ill it with fresh, cold
water and return it to its correct
position.
N
The N icon lights up when the
appliance needs to be descaled.
At this point you can only draw
water by pressing the start/stop
button two times in succession.
Always follow the instructions in
the “Descale” section when you
descale the appliance.
P
The P icon lights up when
the child lock is activated. At
this point the water heater is
deactivated, but you can still
draw room-temperature water.
To learn more about this setting,
read the section titled “Child
lock”.
Using the appliance
General
With this appliance, you can ilter water and
dispense it at room temperature or heated
to speciic temperatures.
If you have questions regarding the ilter
cartridge, contact the BRITA Consumer
Service at 0844 742 4800 (toll-free).
Setting up the appliance
Before you use the appliance for the irst
time, do the following:
► Remove ilm.
► Unroll or push in the right amount of cable
from the cable compartment and plug the
cable into a power outlet.
► Remove the water tank and clean it
thoroughly under running water.
► Insert the ilter cartridge as described
in the section titled “BRITA MAXTRA
water ilter system”.
► Fill the water tank up to the max mark
with fresh, cold water. Use only non-
carbonated drinking water.
► Replace the water tank and push it
irmly downward into place.
Filtrino_H1_all_languages.indd 17 01.08.2011 10:52:07