Bosch THD2023 Heißwasserspender Filtrino FastCup - Manual (Page 24)

24
Robert Bosch Hausgeräte GmbH
en
Simple troubleshooting
Problem Possible cause Remedy
The appliance is not
working and none of the
control lights are lighting.
The appliance may have no
power supply.
Check the appliance to
see if it is connected to the
power supply.
The machine is running
but it is not producing any
water.
The water tank is not itted
correctly.
Please check that the water
tank is correctly itted.
The water tank was
removed during the brewing
stage or there is air in the
system.
Draw the water once again.
The loat in the water tank
is stuck.
Clean the water tank and
release the loat.
It is not possible to set the
temperature.
The child-proof lock is
activated.
Deactivate the child-proof
lock.
M and N are both lashing
at the same time. There is
more water to be drawn.
There has been no hot
water drawn for some
time. The appliance should
be descaled for hygienic
reasons.
Set the temperature to 90°C
or Q and draw hot water
(1 x). M and N extinguish;
the temperature last set
lights up.
The water splutters when
drawn.
The cup stand is set too
low.
Reduce the distance
between the water outlet
and the cup by raising the
cup stand.
Build-up of limescale in the
water outlet.
Descale the appliance as
described in the chapter
“Descaling”.
The temperature of the
water drawn is too low.
The temperature set dis-
plays the water temperature
directly at the water outlet.
Select a higher temperature.
The glass or cup is too cold. Rinse out the glass or cup
with hot water before illing
it or draw water irst to heat
it up.
If you are unable to rectify the problem, please contact Customer Service.
Filtrino_H1_all_languages.indd 24 01.08.2011 10:52:09