Alliance Laundry Systems PHM1401C - Manual (Page 32)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 30 F8138801
Programming UniLinc
System Menu
The System Menu allows the user to access: cycle
programming, diagnostics, laundry management,
bearing timer reset/reset bearing timer.
Press and hold , then, , then to enter
the System Menu.
The System Menu is a submenu of the Cycle Menu.
The navigation of the System Menu is different from
the Cycle Menu. In the Cycle Menu, the highlighted
text box was stationary. In the System Menu, the
ARROW keypads control the location of the
highlighted text box. Text will remain at the same
location but the highlighted box will move when the
text box when the , , , and
keypads are pressed.
Press the keypad to enter selected menu.
Press the keypad to return to the Cycle Menu
screen.
If the user highlights Reset Bearing Timer and presses
the keypad, the text changes to Bearing Timer
Reset and the control resets the total operation time
since the bearings were last serviced. This menu item
will not be an option on machines that do not have a
greasable bearing.
Save Changes Menu
The Save Changes Menu is used to confirm
programming changes when modifying a cycle or the
parameters of the Global Settings. The Save Changes
Menu will default to Yes. Using the or
keypad will move the cursor between Yes or No. Press
the keypad to make a selection. Once the
keypad is pressed, the display will either return to the
Modify Cycle Menu or the Global Setup Menu
depending in which submenu the display was in.
PHM1020R
Figure 23
Laundry
Management
System Menu
Reset Bearing
Timer
Diagnostic Program
PHM1021R
Figure 24
Save Changes?
No Yes