E-Mon Energy Software - Manual (Page 145)

Access Location
E-Mon Energy User Manual 14-8 E-MON
Verify Meters Button
The Verify Meter tells us the condition and if the services are functioning properly. If a meter configuration
mismatch occurs, a warning will display in this window. The illustration below shows that the Meters are
functioning properly.
Figure 14.13 - Access Location Function – Verify Meters
Columns Description
Status This column displays the condition of the device. If the condition
states “Bad” or “Timeout,” there is a possible error in reading the
device and there may be a hardware or communication issue. If the
condition is “ok,” the hardware is functioning normally.
ID This column displays the meter ID number.
Volt This column displays the rated voltage setting.
Amp This column displays the rated amperage setting.
CTs This column displays the number of sets of current sensors.
Pulse This column displays the pulse input type setting (i.e. 50/50, Run-
hour, Analog).
Mfg (manufacture) This column displays the manufacture name of the meter.
Type This column displays the type of service of the meter (i.e. Electric,
Gas).
Mult (Multiplier) This column displays the meter multiplier.
Pul (Pulse) Factor This column displays the meter pulse factor setting.
CT/PT This column displays the “current transformer” and “potential
transformer” setting.
Warnings This column displays any alarms and/or configuration mismatch
with the meter. Note: E-Mon Energy™ compares settings
programmed into the meter with settings stored in the database.
They should be identical.