E-Mon Energy Software - Manual (Page 79)

Recorder
E-Mon Energy User Manual 8-2 E-MON
Panel Group/Field Description
Recorder Panel Group
Device ID* This entry field is fixed and cannot be changed. You can add a new recorder if
you click on the + panel button. This will clear all fields ready for new
recorder information. It is highly recommended not to add recorders
manually. Instead, make use of the Scan new hardware option.
Location No. This field is fixed and cannot be changed. This field will always display the
current Location number selected.
Group No. This field is fixed and cannot be changed. This field will always display the
current Group number selected.
Recorder Name Panel Group
Recorder Name Type in a recorder name. This is an optional field; however, we suggest you
provide a meaningful name. By default, E-Mon Energy™ will assign group,
location, and recorder ID.
ID Type in an identification number for the recorder.
SN Type in the serial number for the recorder. The serial number is located on the
actual hardware label.
Ver. This field is normally populated by E-Mon Energy after scanning the device.
It is used for keep tracking of the recorder firmware.
Data Recorder
Parameters Panel Group
Profile Interval Select the sampling rate for recording interval data with date/time stamp.
Peak Demand Select the peak demand interval (15, 30, or 60 minutes) to calculate peak
usage.
Rolling Demand Select the rolling demand window period (values = 5-minute, 15-minute,
Reset at EOI).
End of Interval At the present time, this setting is defaulted to “Built-In Clock.”
Time Adjustment These two fields allow you to set the minimum and maximum time range for
automatic real-time clock adjustment.
Time Zone Select the Time Zone where the recorder is physically located.
Enable DS Time This checkbox allows you to choose Daylight Savings if this is pertinent to
your time zone.
Use Location Setup If you want the recorder to inherit the Location setup, check the “Use
Location Setup” and all fields in this panel group will be populated with
information from the Location tab.
Password Definition Select the Password Definition name that is created on the Security panel of
the Others tab in the Database window.
Use Location Password If you want the recorder to inherit the Location setup, check the “Use
Location Password” and all fields in this panel group will be populated with
information from the Location tab.
* = Required field.