Fairbanks FB3000 Highway System Application - Manual (Page 71)

Section 4: Inbound/Outbound Weighment Mode
7/08 71 51188 Rev. 1
4.2.3. Processing an Outbound Weighment
1. Press .
2. Enter all the Truck’s information.
(Fields listed below are required for an
Outbound Weighment , and are setup in
3.5.11 . )
─ TRUCK ID.
ƒ Press F3 to display the list of Inbound
trucks for selection. If an invalid Truck
ID/Loop ID is entered, the list of
Inbound Trucks displays for selection.
─ Driver’s Name.
─ Truck Color.
─ [Current] Weather Conditions.
─ Weigh Master [Operator].
─ Trailer Number.
─ Any other displayed prompt.
3. Press one of the following buttons.
─ The instrument prompts to
PRINT, EDIT , or CANCEL .
4. Press Print to complete the transaction.
─ The ticket prints, and is given to the
driver.
─ The Traffic Light changes to
green, and the truck exits.
5. Press Edit to change and of the entries.
6. Press Cancel to abort the transaction.
Data is stored as a completed
transaction.
Select Inbound, Outbound , or Print. The traffic
light displays RED while processing a weighment.
Enter the TRUCK ID, then fill in all of its fields.
Pressing Print completes the transaction.
Whether full or empty, an Outbound Weighment Load is opposite from the Inbound Load .
The difference between the two is the Net Weight .