Ransburg REA Automatic Applicators 77359, 76110, 77140 - Manual (Page 30)

SERVICE - REA 9000W SERIES
All repairs should be made on a clean, flat sur-
face. If a vise is used to hold parts during service
or repair, DO NOT clamp onto plastic parts and
always pad the vise jaws!
The following parts should be thoroughly packed
with LSCH0009-00 dielectric grease leaving NO
air space or voids when assembling.
• All o-rings (o-rings do not need lubrication),
chevron seals and all internal and external
threads.
• Needle shaft LREA4005-00
• Transformer assembly LREA4004-00
REPLACEMENT
PROCEDURE
(REA 9000R, 9000W and 900A)
TO REMOVE THE
APPLICATOR FROM THE
WORK SITE
1. Turn the control unit power OFF.
2. Detach voltage cable from applicator.
3. Turn the paint supply OFF.
4. Turn the atomizing air supply OFF.
5. Properly flush the applicator.
6. Remove air actuation fittings.
7. Remove fluid in and out lines.
8. Remove the applicator from the work site
(and voltage cable, if necessary).
EQUIPMENT REQUIRED
(REA 9000R, 9000W and 900A)
• 19749-00 spanner (nozzle) wrench (3 in 1)
for barrel nut, fluid nozzle, and
needle shaft assembly
• Screwdriver (broad)
• Dielectric grease (59972-00) or
LSCH0009-00
• 1/2-inch (13mm) nut driver
• 9/16-inch socket and handle
• Adjustable wrenches
C A U T I O N
!
>
Failure to pack the needle electrode/electrode
shaft assembly and packing tube MAY CAUSE
lower electrical output of the applicator.
C A U T I O N
!
>
ALWAYS remove the applicator from the
work site for service or repair! DO NOT USE
any silicone lubricants in order to avoid paint
defects.
W A R N I N G
!
>
PRIOR to performing a applicator removal, be
sure ALL power to the control unit is turned off.
Ransburg
REA Automatic Applicators - Maintenance
26 AA-99-02.5