ALESIS MIXING CONSOLES - Manual (Page 11)

SECTION 1
6
2) Pressing the EDIT button again will select the upper LED which
indicates that the top row of edit functions on the top row of
buttons can be accessed.
3) Select the desired function to be edited. The stored value of
the parameter will appear in the numeric display and the
button will light up.
4) Press either VALUE button to adjust the desired parameter.
5) Select another function to be edited, if desired.
PLEASE NOTE:
—
Once a parameter has been edited, the dot to the right of the right-
most numeric digit will light when in PROGRAM mode (program
number displayed and PROGRAM LED lit).
—
At this point, selecting a new program either by the VALUE buttons or
the keypad will cause the edited program to be lost. Be sure to save
your program first (See Saving Edited Programs)!
—
The Edit function has no effect on the bottom row of buttons. They
will operate the same regardless which Edit LED is on.
COMPARING AN EDITED TO A STORED PROGRAM
1) To compare an edited program to the previously stored
program, exit the Edit mode by pressing the PROGRAM button.
The PROGRAM LED will light and the display will show the
program number with a dot to the lower right.
2) Press the PROGRAM button a second time to hear the
previously stored program. The dot displayed behind the
program will flash.
3) Press the PROGRAM button again to listen to the edited
program again. The dot displayed behind the program will turn
solid again.
By repeatedly pressing the
PROGRAM button, you can quickly
change back between the edited and stored program.
4) Press the EDIT button to return to editing, or store as a new
program (see the next function).