ALESIS MIXING CONSOLES - Manual (Page 59)

SECTION 4
54
MISCELLANEOUS FUNCTIONS
INITIALIZING THE MIDIVERB III
There are two reasons why you may want to reinitialize your
MIDIVERB III :
1) To return all programs to their factory parameter settings (called
"initializing").
2) In case the unit locks up from a power surge.
To initialize your MIDIVERB III, do the following:
1) Turn the MIDIVERB III off.
2) Hold the INT. PROG and STORE buttons.
3) Turn the MIDIVERB III on again while holding the above
buttons.
---
PLEASE NOTE:
—
This procedure will erase all user stored parameters and return all
MIDIVERB III parameters to their default values.
—
The MIDI program table will return to 000 through 199.
—
Programs 100 through 199 will become duplicates of factory
programs 000 through 099.
—
The display will be blank for about ten seconds while the memory is
initialized.
CAUTION: This procedure will erase all user programs from memory!!