ALESIS MIXING CONSOLES - Manual (Page 35)

SECTION 4
30
INPUT EQ
The INPUT EQ is a high-cut filter that rolls off the high frequency
response of the input signal before it is sent to either the Delay, Reverb,
or Chorus. The
VALUE button selects the frequency where the signal has
been rolled off -3dB. See Figure 7.
EFFECT EQ
The EFFECT EQ is a high-cut filter that is part of the currently selected
effect. The
VALUE button selects the frequency where the signal has
been rolled off -3dB. See Figure 7.
With effects that have reverb (Configurations 1 through 13), the EFFECT
EQ determines the high frequency decay of the reverb.
With effects
that have Delay (Configurations 14 and 15), the EFFECT EQ determines
the frequency response of the Delay Regeneration (or the number of
repeats).
MIX PARAMETERS
When in the EDIT mode, pressing the MIX button will adjust the relative
level of either the Delay or Reverb, depending on which page the Edit
LED is set. The programmable Mix Parameters are especially useful in
live situations where the level of Delay and Reverb must be different
from program to program.
The Chorus level is always the same and is either On or Off depending
upon the Configuration selected.
The Mix parameters are:
DELAY OUTPUT
LEVEL
The Delay Output Level adjusts the output level of the Delay section.
REVERB OUTPUT
LEVEL
The Reverb Output Level adjusts the output level of the Reverb section.