ALESIS MIXING CONSOLES - Manual (Page 15)

SECTION 2
10
VALUE
The VALUE buttons can be used to select the desired number or, once a
desired parameter has been selected, edit the parameters value.
PROGRAM
The PROGRAM button will display the number of the current program.
A period appearing behind the program number indicates that a
parameter or function has been edited and is different from its stored
value.
STORE
The STORE button allows you to store an edited program into any
available program location. By pressing the STORE button once, the de-
sired location to be stored to can be accessed by pressing and holding
one of the
VALUE buttons. Pressing the STORE button a second time will
save the program.
EDIT
Pressing the EDIT button will allow access to various parameters for
editing. When the EDIT button is selected, the lower of the two LEDs
adjacent to the button will light, and indicates that the lower row of
parameters of the top row of buttons can be accessed for editing.
Pressing the
EDIT button a second time will select the upper row of
parameters of the top row of buttons.
REVERB/1
When in the EDIT mode, pressing the REVERB button will access either
the REVERB ALGORITHM or REVERB DECAY time for editing,
depending which EDIT LED is lit. The ALGORITHM parameter offers
selection of any of 20 Reverb Algorithms, each with different reverb
characteristics such as frequency response, diffusion, density, etc.(see
programming chart). The REVERB DECAY parameter allows the user to
adjust the decay of the reverb from very short to very long as required.
After pressing the
REVERB button, pressing the VALUE buttons will select
the desired ALGORITHM choices or DECAY levels.
When in the PROGRAM mode, this is button 1 of the keypad for
selecting a program by directly entering the desired program number.