Gilderfluke&Co PA System - Manual (Page 26)

m) microphone buttons:
This command brings up this second menu. This is where the functions assigned to all of
the buttons are set up.
- SMART PUBLIC ADDRESS STATION - rev 1.00 copyright 1992 GILDERFLUKE & Co. DCM -
BUTTON LOCKS |__LCD DISPLAY__| TYPE ZONE
PTT __3__6__ _______0________ PA 00
a) button | 0) none | O) string 1- abcefghijkl
b) locks used | 1) mute | P) string 2- abcefghijkl
c) LCD string | 2) unmute | Q) string 3- abcefghijkl
d) access type | 3) half mute | R) string 4- abcefghijkl
e) zone number | 4) toggle mute | S) string 5- abcefghijkl
f) aux. string- none | 5) toggle half mute | T) string 6- abcefghijkl
| 6) rotate thru mutes | U) string 7- abcefghijkl
h) zone entry column- F | 7) volume to minimum |
i) vol. zone column- 0 | 8) volume to maximum |
| 9) volume down |
m) back to setup menu | A) volume up |
x) eXit | B) volume alternate U/D |
| C) repeater string |
| D) terminal string |
| E) printer string |
| F) PA access |
Enter command-
The upper part of the screen shows all of the configuration data for the currently selected button just
as it was seen on the previous screen. The commands available to you are shown in the left and right
columns.
a) button:
This is used to select which of the 19 possible buttons you would like to configure.
Selecting a different button will automatically write any changes you have made in he cur-
rent button to the EEPROM.
b) locks used:
This command is used to select which of the eight possible locks are used for this key.
Any number from none to all eight can be used for a single key.
c) LCD string:
This command allows you to enter what will be displayed on the LCD display on the front
of the Smart PA Station when this button is pushed. If the button is ÔhardwiredÕ to select a
specific zone number, then you will probably want to enter a description of the area ac-
cessed by the zone number selected. You will want to prompt the users to enter a zone
number if one is needed.
d) access type:
This command is used to select what type of access this button will make. The options
are shown in the center column of this screen. They are:
0) none. This key doesnÕt do anything but put whatever is in the LCD string onto the display.
1) Mute a zone. Any of the eight possible mute zones can be activated by a button which
has this function enabled. Any MA-100/200 output or DR-100/300/400 which has been
configured to respond to the requested mute zone will be muted. A full mute will take
precedence over any half mutes active on the same outputs.
2) Un-mute a zone. This command will configure this button to remove both full and half
mutes from the selected zone when it is pressed. Any MA-100/200 output or DR-
100/300/400 which has been muted or half muted by this zone will have itÕs audio re-
turned to itÕs normal audio level.
G ILDERFLUKE & C O . ¥ 205 S OUTH F LOWER S T . ¥ B URBANK , C ALIF . 91502-2102 ¥ 818/840-9484 ¥ FAX 818/840-9485
22 of 35