R) repeaters – Gilderfluke&Co PA System User Manual
Page 31
¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥
r) Repeaters:
This command is used to set up any Digital Audio Repeaters or Smart Brick Animation Control Systems
attached to the PA System.
The PA System first asks you for the address of the repeater you would like to configure (or you can
enter the address of any Smart Brick Animation System just as you would a repeater). If there was any-
thing located at the address you specified, it will put its configuration menu up on the screen (see the
Digital Audio Repeater and Smart Brick System manuals for the configuration of these screens).
If there is nothing at the specified address, the screen wonÕt change when you enter the address. To
exit this mode you must enter ÔxÕ and then ÔnÕ. The screen will then return to the first menu
G
ILDERFLUKE
& C
O
. ¥ 205 S
OUTH
F
LOWER
S
T
. ¥ B
URBANK
, C
ALIF
. 91502-2102 ¥ 818/840-9484 ¥
FAX
818/840-9485
27 of 35