Gilderfluke&Co PA System User Manual
Page 28
E)
Printer String. When this function is selected, then the string selected by the AUX.
STRING is sent to the Printer port on the MA-100 when this button is pressed.
F)
Access a PA Zone. Depending on the Zone number entered, this can be an access to a
specific PA zone, or to the corresponding MA-100/200 output.
e) zone number:
This command is used to select what zone number will be accessed by this button. If you
enter a ÔhardwiredÕ zone number, that will be the zone accessed by this button every time. If
you select USER ZONE ENTRY, then the user will have to select the the zone to be accessed
by this button. For all but PA zone accesses, valid zone numbers are from 1 through 8. PA
zones can be entered between 00 and FE. Entering a FF will cause this PA station to access
itÕs corresponding local MA-100/200 output. This command is invalid if the access type is set
for any of the Ôsend stringÕ commands.
f)
aux. string:
This command is used to select which text string will be sent out by pressing this button. If
any of the Ôsend stringÕ commands are selected, then the appropriate port will be the desti-
nation of the string. If any other type of access is selected then the string will be sent to the
repeater port. The strings can be used to tell another piece of equipment to do something.
An example of this would be to send a string to the repeaters which selects and plays a
specific spiel when a button on the PA station is pressed.
h) zone entry column:
This command allows you to select what column on the LCD display the zone number
will appear when the user is entering it.
i)
vol. zone column:
This command allows you to select what column on the LCD display the current volume
will be displayed in when accessing any volume zone.
m) back to setup menu:
This command brings you back to the first Smart PA Station setup menu.
O) string 1:
P) string 2:
Q) string 3:
R) string 4:
S)
string 5:
T)
string 6:
U) string 7:
These commands allow you to enter the text strings to be sent to the printer, terminal, or
most commonly, the Repeater port on the MA-100. Typical uses for these keys are to start
another piece of equipment attached to the system. An example of this would be to send a
string to the repeaters which selects and plays a specific spiel when a button on the PA sta-
tion is pressed.
x)
eXit:
This command brings you back directly to the MA-100 setup menu. On the way out you
get the option of saving the current configuration to the EEPROM or not.
G
ILDERFLUKE
& C
O
. ¥ 205 S
OUTH
F
LOWER
S
T
. ¥ B
URBANK
, C
ALIF
. 91502-2102 ¥ 818/840-9484 ¥
FAX
818/840-9485
24 of 35