Hardware debug mode – Gilderfluke&Co PA System User Manual
Page 34
- Hardware Debug Mode -
This mode is entered while in the first setup menu by pressing the Т+У key on your terminal. Nothing
will be apparent at the time, but when you exit the configuration mode, several new commands will be
available to you. These are normally used only for testing or repairing the PA system hardware. As such,
users should never need to get into this mode.
To exit this mode, you can power down the MA-100 or reenter the first configuration mode screen.
Pressing a second Т+У will take you out of this mode. Note that when in this mode, the console clock dis-
play is disabled. It will return as soon as this mode is exited.
If you wish to see a listing of the commands available to you in Hardware Debug Mode, enter the
mode and send an <ESC>ape to the MA-100. This displays a short menu.
G
ILDERFLUKE
& C
O
. ¥ 205 S
OUTH
F
LOWER
S
T
. ¥ B
URBANK
, C
ALIF
. 91502-2102 ¥ 818/840-9484 ¥
FAX
818/840-9485
30 of 35