Teledyne LeCroy WaveAce 1000_2000 - Manual (Page 12)

WaveAce 1000/2000
6 922131-00 Rev A
Power Consumption
< 50 Watts for all models (depending on accessories installed - probes, USB
devices, etc.).
Power consumption in Standby Mode: < 5 Watts.
Power and Ground Connections
The instrument is provided with a 10A/250V 18AWG rated grounded cord set
containing a molded three-terminal polarized plug and a standard IEC-60320
(Type C13) connector for making line voltage and safety ground connections.
The AC inlet ground is connected directly to the frame of the instrument. For
adequate protection again electric shock, connect to a mating outlet with a
safety ground contact.
WARNING. Interrupting the protective conductor inside or outside
the oscilloscope, or disconnecting the safety ground terminal, creates
a hazardous situation. Intentional interruption is prohibited.
Standby Power
The Power (Standby) button controls the operational state of the
oscilloscope. Press the button to switch the instrument On or into Standby
mode (Off).
Always use the Power button to execute a proper shut down process and
preserve settings before powering down.
Powering off does not disconnect the oscilloscope from the AC power supply.
The only way to fully power down the instrument is to shut down then unplug
the AC power cord from the outlet.
We recommend unplugging the instrument if it will be unused for a long
period of time.