Teledyne LeCroy WaveAce 1000_2000 - Manual (Page 19)

Operator’s Manual
922131-00 Rev A 13
General Control Buttons
Note: Exact Help, Default Setup, and AUTO button locations vary on 4 and 2
Channel models.

HELP - Displays context-sensitive online help. Press Help, and then
another front panel button and information pertaining to the selected
button is shown.

DEFAULT SETUP - Press to reset the oscilloscope's settings to the
default factory configuration. For a list of default settings, see Recalling
Factory Settings (on page 62).

AUTO - Press to have the oscilloscope automatically identify the type of
waveform and adjust the controls to produce a usable display of the
input signal. When you press the AUTO front panel button, the Auto Set
menu opens. You can use this menu to display multiple-cycle signals, a
single-cycle signal, the rising edge, the falling edge or recall the previous
setup.
Run Control Buttons

SINGLE - Press to acquire a single waveform. Each time you press the
SINGLE button, the oscilloscope acquires another waveform. When the
oscilloscope detects a trigger it completes the acquisition and stops.

RUN/STOP - Press when you want the oscilloscope to acquire
waveforms continuously. Press RUN/STOP again to stop the acquisition.
See the Acquiring Waveforms section of Acquisition Types (on page 29) for
more information.