Teledyne LeCroy WaveAce 1000_2000 - Manual (Page 79)

Operator’s Manual
922131-00 Rev A 73
D O S ELF T EST
1. Press the Do Self Test option button to perform a self-test. A separate
SELF TEST screen is then shown.
2. Choose from Screen, Keyboard, or LED tests by pressing the respective
option button.
3. After making your selection a corresponding screen is shown where
either the SINGLE or RUN/STOP front panel button is used to complete
the test and/or exit the test screen, respectively. Screen, Keyboard, and
LED Test screens look like the following:
NOTE: After using corresponding option buttons to choose Do Self Cal,
Do Self Test, or Print Setup (when enabled by selecting Printer on the
Back USB option button), you're taken to a separate menu based on
your selection where additional options are then shown. You can
always return to the original menu from this menu by pressing the
UTILITY front panel button.