Teledyne LeCroy WaveAce 1000_2000 - Manual (Page 82)

WaveAce 1000/2000
76 922131-00 Rev A
Utility Menu - Page 3/4
1. Press the Update Firmware option button to update the oscilloscope
using the USB memory device. For more information, see the Updating
the System Software (on page 80) section.
2. Pressing the Pass/Fail option button shows the Pass/Fail menu where
you can monitor changes of signals and output pass or fail signals by
judging whether the input signal is within the predefined mask. For
more information, see Using Pass/Fail (on page 82).
3. Pressing the Record option button shows the Record menu where you
can record the input waveform from CH1 and CH2 (also, CH3 and CH4
on four channel versions), with a maximum record length of 2500
frames.
You can record Pass/Fail test output (especially useful when capturing
abnormal signals over a long period of time) without having to watch
the signal.
Just set the source, the time interval between record frames, and the
maximum number of record frames. For more information, see Using
Record (on page 85).
4. With your oscilloscope connected to your network, pressing the IP
Setting option button shows Internet Protocol values for your specific
IP Address, Subnet Mask, Gate Way, Port, Mac Address, and DHCP.