Teledyne LeCroy SierraNet M408 User Manual Ver.1.50 - Manual (Page 222)

Teledyne LeCroy InFusion Scenarios
220 SierraNet M408 Protocol Analyzer User Manual
Dword #0, #1, #2 and #3 and when your detector is Pattern Detector you can use Dword
#4, #5, #6 and #7. When trying to use the captured dword, for example in Replace Dword
Action, you can actually select from 8 captured dwords, numbered 0 through 7.
To capture a data dword, select Capture Dword from the Action Properties screen (see
Figure 4.8 on page 220 ). Select the location you would like the captured Dword to be
stored in, so it can be used in a later replacement or insertion.
Figure 4.8: Capture Data Dword Action
4.5.8 Using Captured Data Dwords
Captured data dwords can be used in creating Events for data that match the captured
dword(s), or in creating Actions to substitute or insert the captured dword(s) into the
data stream.
To create an Event using the captured dword, in the Add Event dialog (see Figure 4.9 on
page 221 ), select Dword Matcher and change the Type to the desired Captured Dword
number. Note that choice of a mask and an offset are still available. Select the code mask
from the drop‐down menu.