Teledyne LeCroy SierraNet M408 User Manual Ver.1.50 - Manual (Page 35)

SierraNet M408 User Manual 33
Protocol Analyzer Teledyne LeCroy
After the update, the device must restart.
Figure 1.26: Info Dialog
Then the update is complete.
The connection may freeze when the unit reboots after the firmware update. Perform the
following steps to recover:
1. Click OK on the error message in the Info dialog.
2. Click Close to close the Device Setup dialog.
3. Click Refresh Device List in the Device Management dialog (see
Figure 1.20 on
page 27 ).
4. Click Disconnect.
Figure 1.27: Device Setup Dialog with OK Device Status
Note: Do not shut down or power cycle the analyzer during this process.
1.7 Protocol Analyzer
To use the software for protocol analysis, first select File > New Project for a new project
or File > Open to open an existing protocol analysis .gep file. (see
“Protocol Analysis” on