Teledyne LeCroy SierraNet M408 User Manual Ver.1.50 - Manual (Page 96)

Teledyne LeCroy Trigger and Filter Settings in Easy Mode
94 SierraNet M408 User Manual
Link Control Frame
For any FCoE pattern, double‐click the pattern name, for example, double‐click Basic Link
Service to open the Basic Link Service Pattern dialog.
Note: Some screen captures for the FCoE patterns are similar to the screen capture shown below.
Figure 2.67: Link Control Frame Pattern Dialog
Enter the values for the Ethernet header, FCoE header, Frame header and the count of
the expected number of occurrences. Check the Check All box to select ports P1 through
P8 or individually select ports.
Check the Trigger on given pattern with variable header length box to automatically
adjust the offset, if optional headers like VLAN tag, VNTag, etc. are present. Uncheck it, to
trigger for a pattern at a specific offset from the start of the frame.
The following additional Ethernet patterns are available:
FCP Patterns
Frame Information Unit
 FCP Frame Information Unit (Any)
 FCP Frame Information Unit (Data)
 FCP Frame Information Unit (Confirm)
 FCP Frame Information Unit (XFER READY)
 FCP Frame Information Unit (Command)
 FCP Frame Information Unit (Response)