Teledyne LeCroy SierraNet M408 User Manual Ver.1.50 - Manual (Page 230)

Teledyne LeCroy Scenario Example
228 SierraNet M408 Protocol Analyzer User Manual
5. Select Replace DWORD in the Action panel and place it in the Global Rules panel
(see Figure 4.18 on page 228 ).
6. Right‐click the New Scenario tab and select Rename Scenario and enter the name in
the Library panel as shown in Figure 4.18 on page 228
Figure 4.18: Global Rules ‐ Naming a Scenario
Adding a Sequence
To add a Sequence click Add State in the Sequence 1 panel.
You create a sequence one state at a time. The application numbers states consecutively
from 0 up (1, 2, 3, and so on).
By default, the name of the first sequence in a Scenario is Sequence 1. The name of the
first state is State 0. To change the name of a sequence or state, or to associate a
description with it, click the name of the sequence or state..
1. Drag 6‐Byte Any SCSI Command under FCP as the Event to display the dialog.