Teledyne LeCroy SierraNet M408 User Manual Ver.1.50 - Manual (Page 39)

SierraNet M408 User Manual 37
Chapter 2
Protocol Analysis
The system performs Protocol Analysis by defining and running an analysis project for
both Fibre Channel over Ethernet (FCoE) and Fibre Channel (FC) depending on the
Analyzer that you are connected to. This is saved in a file with the .get extension. An
analysis project definition defines what to capture, what the analyzer triggers on, and the
memory settings. You can save defined projects as project *.gep files for later use.
After you install the Analyzer software (see “Software Installation” on page 14 ) and set up
the Analyzer (see “Hardware Setup” on page 14 ), launch the Analyzer software (see
“Launching Your Analyzer” on page 21 ) to display the main window.
Figure 2.1: Teledyne LeCroy Ethernet Protocol Suite Main Window