3 setting up for generating initiator traffic, 4 setting up for generating target traffic, 5 creating a traffic generation file – Teledyne LeCroy Sierra M122 User Manual User Manual
Page 287
Sierra M122 SAS/SATA Protocol Analyzer User Manual
285
Setting Up for Generating Initiator Traffic
Teledyne LeCroy
5.3
Setting Up for Generating Initiator Traffic
Connect the SAS cable from the Target port of the Sierra Analyzer to the Target port on
the unit under test. This transmits the Traffic Generator stream from the Target port to
the target‐side port on the unit under test.
5.4
Setting Up for Generating Target Traffic
Connect the SAS cable from the Initiator port of the Sierra Analyzer to the
Initiator‐side port on the unit under test. This transmits the Traffic Generator stream from
the Initiator port to the initiator‐side port on the unit under test.
5.5
Creating a Traffic Generation File
Generating traffic is a two‐step process.
Zoom In.
Zoom Out.
Wrap.
Find.
Find Next.
Start All Generation.
Stop All Generation.
Resume All Generation.
Connect All Link.
Disconnect All Link.
Setup Generation Options.
Opens the Generation Options
window.
Launch Jammer (Infusion).
Launch Analyzer.
Start Recording.
Stop Recording.
Abort Recording.
Show Port Configuration Dialog.
(See
Show Script Assignment
Dialog.
(See section below.)
Tile Windows
Assign Active Script/
Remove Assigned
Script for
Link 1, 2, 3, or 4
See
Assignments to Links” on page
298
.