Teledyne LeCroy QPHY-HDMI - Manual (Page 11)

QPHY-HDMI Operator’s Manual
QualiPHY Test Process
Once general system settings are in place, these are the steps for running test sessions.
Set Up Test Session
1. Connect the oscilloscope to the DUT. See QPHY-HDMI Testing Physical Setup .
2. Access the QualiPHY software to display the framework dialog.
3. If running QualiPHY remotely, click General Setup and open the Scope Selector to
select the correct oscilloscope connection.
4. If you have more than one component activated, click Standard and select the desired
standard to test against. Otherwise, your one activated component will appear as the
default selection.
Note: Although all the QualiPHY components appear on this dialog, only those selected
when installing QualiPHY are enabled for selection.
5. Click the Configuration button and select the test configuration to run. These pre-
loaded configurations are set up to run all the tests required for compliance and provide
a quick, easy way to begin compliance testing. See
QPHY-HDMI Test Configurations for
a description of your configurations.
You can also create custom configurations for internal compliance tests by copying and
modifying the pre-loaded configurations. See
Customizing QualiPHY for details.
6. Close the Edit/View Configuration dialog to return to the framework dialog.
922540 Rev A 7