Teledyne LeCroy QPHY-HDMI - Manual (Page 13)

QPHY-HDMI Operator’s Manual
Run Reports
The QualiPHY software automates report generation. On the framework dialog, go to General
Setup > Report to pre-configure reporting behavior. You can also manually launch the Report
Generator from the framework dialog once a test is run.
The Report Generator offers the same selections as the Report tab, only applied to each report
individually, rather than as a system setting. This enables you to save reports for each test
session, rather than overwrite the generic report file. There are also options to link a custom
style sheet (.xslt) to the report, or to Exclude Informative Results.
The Test Report includes a summary table with links to the detailed test result pages.
Figure 2 - The Test Report Summary Table and Detail page.
Reports are output to the base installation folder *\LeCroy\XReplay\Reports.
You can add your own logo to the report by replacing the file
*\LeCroy\XReplay\StyleSheets\CustomerLogo.jpg.
The recommended maximum size is 250x100 pixels at 72 ppi, 16.7 million colors, 24 bits. Use
the same file name and format.
922540 Rev A 9