Teledyne LeCroy QPHY-HDMI - Manual (Page 6)

Test Fixtures
Teledyne LeCroy recommends using the Wilder Technologies HDMI-TPA-P (plug test adapter)
used in conjunction with HDMI-TPA-E (EDID board with EEPROM). This equipment is available
from Wilder Technologies individually or as part of the HDMI-TPA-PRRCE Test Adapter Kit. The
HDMI-TPA-PRRCE test adapter kit provides a very high bandwidth, low noise evaluation vehicle
that enables high-performance characterization of both plug and receptacle HDMI™ devices
with bandwidth greatly exceeding the 340 MHz (10.2 Gbps) of the latest v1.4b HDMI
specification.
Required Host Computer System
Usually, the oscilloscope is the host computer for the QualiPHY software, and all models that
meet the acquisition requirements will also meet the host system requirements. However, if you
wish to run the QualiPHY software from a remote computer, these minimum requirements apply:
• Operating System:
o Windows 2000 Professional with service pack 4
o Windows XP Professional with service pack 2
o Windows VISTA with service pack 1
o Windows 7 Professional
• 1 GHz or faster processor
• 1 GB (32-bit) or 2 GB (64-bit) of RAM
• Ethernet (LAN) network capability
• Hard Drive:
o At least 100 MB free to install the framework application
o Up to 1GB per standard installed to store the log database (each database grows
from a few MB to a maximum of 1 GB)
See Set Up Remote Control for configuration instructions.
2 922540 Rev A