IEI Integration IMBA-9454 v4.02 - Manual (Page 102)

IMBA-9454G Motherboard
Page 84
5.4.1 CF Master/Slave Selection
Jumper Label:
JP2
Jumper Type: 2-pin header
Jumper Settings: See Table 5-2
The CF Master/Slave Selection jumper sets the CF Type I card or CF Type II cards as
either the slave device or the master device. CF Master/Slave Selection jumper settings
are shown in Table 5-2.
Pins Description
Open Slave Default
Short Master
Table 5-2: CF Master/Slave Selection Settings
Figure 5-9: Jumper Locations
5.4.2 Clear CMOS Jumper
Jumper Label: JP1
Jumper Type: 3-pin header
Jumper Settings: See Table 5-3
If the IMBA-9454G fails to boot due to improper BIOS settings, the clear CMOS jumper
clears the CMOS data and resets the system BIOS information. To do this, use the jumper