IEI Integration IMBA-9454 v4.02 - Manual (Page 103)

IMBA-9454G Motherboard
Page 85
cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip back to pins 1
and 2.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
 Enter the correct CMOS setting
 Load Optimal Defaults
 Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in Table 5-3.
Pins Description
Short 1 - 2 Keep CMOS Setup Default
Short 2 – 3 Clear CMOS Setup
Table 5-3: Clear CMOS Jumper Settings
Figure 5-10: Clear CMOS Jumper Location
5.4.3 COM2 Mode Selection
Jumper Label: JP4
Jumper Type: 3-pin header
Jumper Settings: See Table 5-4