IEI Integration IMBA-9454 v4.02 - Manual (Page 108)

IMBA-9454G Motherboard
Page 90
Step 3: Secure the bracket. The dual RS-232 connector has two D-sub 9 male
connectors secured to a bracket. To secure the bracket to a chassis please refer
to the reference material that came with the chassis Step 0:
5.6.4 SATA Drive Connection
The IMBA-9454G is shipped with SATA drive cables and SATA drive power cable. Follow
the steps below to connect the SATA drives to the motherboard.
Step 1: Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
Step 2: Insert the cable connector. Press the clip on the connector at the end of the
SATA cable and insert the cable connector into the onboard SATA drive
connector. See Figure 5-15.
Figure 5-15: SATA Drive Cable Connection