3 dual rs-232 cable connection, Figure 5-14: dual rs-232 cable installation – IEI Integration IMBA-9454 v4.02 User Manual
Page 107
IMBA-9454G Motherboard
Page 89
Step 3:
Connect the cable to an IDE device. Connect the two connectors on the other
side of the cable to one or two IDE devices. Make sure that pin 1 on the cable
corresponds to pin 1 on the connector
Step 0:
5.6.3 Dual RS-232 Cable Connection
The dual RS-232 cable consists of two serial port connectors attached to a serial
communications cable that is then attached to two bracket mounted D-sub 9 male
connectors. To install the dual RS-232 cable, please follow the steps below.
Step 1:
Locate the connector. The location of the RS-232 connector is shown in
Chapter 3.
Step 2:
Insert the cable connector. Insert the connectors into the serial port box
headers. See Figure 5-14. A key on the front of the cable connectors ensures
the connectors can only be installed in one direction.
Figure 5-14: Dual RS-232 Cable Installation