IEI Integration IMBA-9454 v4.02 - Manual (Page 111)

IMBA-9454G Motherboard
Page 93
5.7.2 Parallel Device Connection
The IMBA-9454G has a single female DB-25 connector on the external peripheral
interface panel for parallel devices. Follow the steps below to connect a parallel device to
the IMBA-9454G.
Step 1: Locate the DB-25 connector. The location of the DB-25 connector is shown in
Chapter 3.
Step 2: Insert the DB-25 connector. Insert the DB-25 connector of a parallel device
into the DB-25 connector on the external peripheral interface. See Figure 5-18.
Figure 5-18: Parallel Device Connector
Step 3: Secure the connector. Secure the DB-25 connector to the external interface by
tightening the two retention screws on either side of the connector. Step 0:
5.7.3 RJ-45 Ethernet Connection
The IMBA-9454G has two RJ-45 Ethernet connectors on the external peripheral interface
panel for LAN communications. Follow the steps below to connect an RJ-45 Ethernet
connector to the IMBA-9454G.