Figure 5-4: insert the lga775 cpu – IEI Integration IMBA-9454 v4.02 User Manual
Page 97
IMBA-9454G Motherboard
Page 79
Step 4:
Orientate the CPU properly. Make sure the IHS (Integrated Heat Sink) side is
facing upward.
Step 5:
Correctly position the CPU. Match the Pin 1 mark with the cut edge on the
CPU socket.
Step 6:
Align the CPU pins. Locate pin 1 and the two orientation notches on the CPU.
Carefully match the two orientation notches on the CPU with the socket
alignment keys.
Step 7:
Insert the CPU. Gently insert the CPU into the socket. If the CPU pins are
properly aligned, the CPU should slide into the CPU socket smoothly. See
Figure 5-4: Insert the LGA775 CPU
Step 8:
Close the CPU socket. Close the load plate and engage the load lever by
pushing it back to its original position. Secure the load lever under the retention
tab on the side of CPU socket.
Step 9:
Connect the CPU 12V cable to the 12After the cooling kit is installed
connect the CPU cable to the CPU 12V power connector
Step 0: