IEI Integration WAFER-945GSE v2.01 - Manual (Page 105)

WAFER-945GSE 3.5" Motherboard
Page 90
NOTE:
Identical baud rate setting must be set on the host (a management computer
running a terminal software) and the slave
Redirection After BIOS POST [Always]
Use the Redirection After BIOS POST option to specify when console redirection should
occur.
Disabled The console is not redirected after POST
Boot Loader Redirection is active during POST and during Boot
Loader
Always D EFAULT Redirection is always active (Some OSes may not
work if set to Always)
Terminal Type [ANSI]
Use the Terminal Type BIOS option to specify the remote terminal type.
ANSI D EFAULT The target terminal type is ANSI
VT100 The target terminal type is VT100
VT-UTF8 The target terminal type is VT-UTF8
5.3.7 USB Configuration
Use the USB Configuration menu (BIOS Menu 12) to read USB configuration
information and configure the USB settings.