IEI Integration WAFER-945GSE v2.01 - Manual (Page 59)

WAFER-945GSE 3.5" Motherboard
Page 44
Jumper Label: ATXCTL1
Jumper Type: 3-pin header
Jumper Settings: See Table 4-2
Jumper Location: See Figure 4-3
The AT Power Select jumper specifies the systems power mode as AT or ATX.
Setting Description
Short 2-3 Use AT power (Default)
OFF Use ATX power
Table 4-2: AT Power Select Jumper Settings
Figure 4-3: AT Power Select Jumper Location
4.4.2 CF Card Setup
Jumper Label: JCF1
Jumper Type: 2-pin header
Jumper Settings: See Table 4-3
Jumper Location: See Figure 4-4
The CF Card Setup jumper sets the CF Type I card or CF Type II cards as either the slave
device or the master device.
Setting Description
OFF Slave (Default)