IEI Integration WAFER-945GSE v2.01 - Manual (Page 56)

WAFER-945GSE 3.5" Motherboard
Page 41
4.3 SO-DIMM and CF Card Installation
4.3.1 SO-DIMM Installation
WARNING:
Using incorrectly specified SO-DIMM may cause permanent damage to
the WAFER-945GSE. Please make sure the purchased SO-DIMM
complies with the memory specifications of the WAFER-945GSE.
SO-DIMM specifications compliant with the WAFER-945GSE are listed
in Chapter 1.
To install a SO-DIMM into a SO-DIMM socket, please follow the steps below and refer to
Figure 4-1.
Figure 4-1: SO-DIMM Installation
Step 1: Locate the SO-DIMM socket. Place the WAFER-945GSE on an anti-static pad.
Step 2: Align the SO-DIMM with the socket. The SO-DIMM must be oriented in such a
way that the notch in the middle of the SO-DIMM must be aligned with the
plastic bridge in the socket.
Step 3: Insert the SO-DIMM. Push the SO-DIMM chip into the socket at an angle. (See
Figure 4-1)
Step 4: Open the SO-DIMM socket arms. Gently pull the arms of the SO-DIMM socket
out and push the rear of the SO-DIMM down. (See Figure 4-1)