IEI Integration WAFER-945GSE v2.01 - Manual (Page 72)

WAFER-945GSE 3.5" Motherboard
Page 57
Figure 4-15: Keyboard/mouse Y-cable Connection
Step 4: Attach PS/2 connectors to the chassis. The keyboard/mouse Y-cable
connector is connected to two PS/2 connectors. To secure the PS/2 connectors
to the chassis please refer to the installation instructions that came with the
chassis.
Step 5: Connect the keyboard and mouse. Once the PS/2 connectors are connected
to the chassis, a keyboard and mouse can each be connected to one of the
PS/2 connectors. The keyboard PS/2 connector and mouse PS/2 connector are
both marked. Please make sure the keyboard and mouse are connected to the
correct PS/2 connector.
4.6.6 Audio Kit Installation
The Audio Kit that came with the WAFER-945GSE connects to the 10-pin audio connector
on the WAFER-945GSE. The audio kit consists of three audio jacks. One audio jack, Mic
In, connects to a microphone. The remaining two audio jacks, Line-In and Line-Out,
connect to two speakers. To install the audio kit, please refer to the steps below: