Lincoln Electric 718118 Spirit II 400 - Manual (Page 42)

Section 3: Installation Spirit II User’s Manual
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
3-18
CAN Communication Connections
Perform the following steps to connect the plasma power supply to the MGC.
CAN Cable
• Connect the male end of the CAN cable to the connector labeled P4 on the rear of
the plasma power supply.
• Connect the female end of the CAN cable to the top connector on the rear of the
MGC.
CAN Termination Plug
• If not already installed, connect the CAN termination plug to the bottom connector on
the rear of the MGC.
35
36
35
35
36