SaltDogg 1400465SSH Self-Contained Hopper Spreader - Manual (Page 2)

2
SAE GRADE 2
FT-LBS
SAE GRADE 5
FT-LBS
1/4-20 6 9
5/16-18 11 18
3/8-18 19 31
3/8-24 24 46
7/16-14 30 50
1/2-13 45 75
9/16-12 66 110
5/8-11 93 150
3. Recommended Fastener Torques:
Maintain all fastener torques as shown in the following table.
Failure to do so may cause injury to persons.
Safety Precautions
Installation Instructions
1. Mounting the Spreader onto the Vehicle:
A. Remove the tailgate from the vehicle.
B. Lift the spreader by lifting loops on side of hopper.
1. Read this entire Owner’s Manual before operating this
spreader.
2. Read all safety decals on the spreader before operating the
spreader.
3. Check to make sure all safety guards are securely mounted
into place before operating this spreader.
4. Make sure the motor cover is securely fastened to the
spreader before operating the spreader.
5. Verify that all personnel are clear of the spreader spray area
before starting or operating this spreader.
6. Keep all loose clothing, hair, jewelry and limbs clear of the
spreader before starting or operating this spreader.
7. Do not over-load your vehicle beyond payload limits. If there
are any questions, contact the vehicle manufacturer.
8. Do not adjust, clean, oil or unclog material jams without first
turning off the spreader.
9. Do not climb on or in the spreader during operation. Do not
ride on the spreader while the vehicle is in motion.
10. Make sure the spreader is securely fastened to the vehicle
in accordance with this manual.
11. Do not operate a spreader that is in need of maintenance or
repairs.
12. Always disconnect the wire harness before removing or
replacing any electrical components.
WARNING
Observe the following Safety Precautions before,
during and after operating this spreader. By following
these precautions and common sense, possible injury
to persons and potential damage to this machine may
be avoided.
WARNING
The lifting device must be adequately rated to lift a
payload equal to or greater than the spreader weight.
See page 1 for spreader weights. Empty spreader
before lifting.
C. Elevate the spreader off the vehicle with lumber. Place
lumber under the side gussets of the spreader. This will help
with removal of excess material that accumulates under the
spreader.
D. Center the spreader on the vehicle with the end of the
gear mount 14" to the rear of the nearest vertical obstruction
(bumper, trailer hitch, etc). Attach chute to spreader, check
for interference between the vehicle and the Spinner/Chute
Assembly.
E. Bolt the spreader to the vehicle frame through the lengths
of lumber using the holes located in each of the four (4) side
gussets. Use 1/2" SAE Grade 5 hardware as required by
vehicle application.
F. In addition secure the spreader to the vehicle by attaching
the four (4) tie-down eyes located at each corner of the
spreader to the vehicle’s factory installed anchor points using
suitable tie-down devices.
• The spreader must be securely fastened to the frame of the
vehicle.
• Verify with the vehicle’s manufacturer that the factory
installed anchor points are designed for tie-down of such
load.
• Periodically check that the spreader mounting hardware is
securely tightened, retighten if necessary.