SaltDogg 1400465SSH Self-Contained Hopper Spreader - Manual (Page 4)

4
heat can damage the wire harnesses. Use quick ties to secure
harness to underbody.
J. Connect the wire harness to the motor. Make sure wire
colors on wire harness match colors on the motor.
K. Thoroughly clean battery terminals. Make sure battery
terminals have no tarnish or corrosion.
DO NOT CONNECT
WIRE HARNESS TO DAMAGED OR CORRODED
TERMINALS! IT MAY RESULT IN OVERHEATING, LOST
POWER AND POTENTIAL CONTROLLER DAMAGE!
L. Connect the power cable directly to the battery.
M. Insure all functions of the controller are
working properly.
N. Observe chain moving in proper direction. If direction is
wrong reverse wires between Motor and Wire Harness.
IMPORTANT
Make sure all wires securely attached to vehicle or
spreader. Use wire ties and/or wire clamps to attach
wires. All excess wires must be rolled into bungles and
attached to vehicle or spreader.
O. Optional spot light (5 AMP max) can be installed on
spreader. Remove cap from single white wire. Connect light to
this wire and trucks frame.
3. Spinner/Chute Assembly Operation
A. Attach chute to hopper assembly by inserting bars into holes