Progressive International Electronics RLM - Manual (Page 23)

RLM Progressive International Electronics
Page 14 Version 1.1 / November 98
rlminstl.mnl
3. Referring to Connector/Jumper Layout diagram on the following
page, set all jumpers on the RLM main board according to the
specific application requirements. These settings affect the Tank
Monitor communications parameters such as baud rate, parity,
data bits and device addressing. Also, these jumpers allow the
RLM to be configured for daisy-chaining together using, RS485
multi-drop circuitry. Refer to Diagram: RLM (Mechanical)
Connector/Jumper Layout which follows.
4. Mount pulsers on volume shaft of mechanical dispenser
computer. Refer to diagram on following page.
5. Identify unused switch in electric reset for use as a return switch
on the RLM Mechanical. Refer to diagram on following page.
6. Wire the pulsers and motor return (MR) switches to the RLM
Mechanical. Refer to Diagram: RLM (Mechanical)
Connector/Jumper Layout which follows.
7. Connect a PC to the installed RLM’s communication cable.
8. Plug the wall transformer into the dedicated power outlet to apply
power to the RLM system.
9. Run Tester Program supplied on the system diskette shipped with
the RLM, and perform a preliminary test. Refer to Tester
Program, Preliminary Test, in the Diagnostics section of this
document.