Progressive International Electronics RLM - Manual (Page 26)

Progressive International Electronics RLM
Version 1.1 / November 98 Page 17
rlminstl.mnl
System Installation
Pump Specific Installation
RLM-G for Gilbarco Electronic Dispenser
Note all warnings at the beginning of installation section.
Gilbarco MOC (major oil company) G-SITE Systems are a special
configuration. Refer to System Installation, RLM-GS for Gilbarco G-
SITE Installation, which follows this section, for Gilbarco MOC
instructions and installation requirements.
Following the instructions in RLM General Installation, perform general
installation procedure and the preliminary test procedure using
Tester/WinTester program. Then, follow specific instructions for
connecting the RLM system to the appropriate Gilbarco distribution box
(DBox). See Table: Gilbarco DBoxes at the end of this section.
Match the RLM-G with the Gilbarco system by using the appropriate
adapter board selection in the RLM-G. Reference Diagram: RLM
Gilbarco Adapter Board later in this section.
1. If the Gilbarco system employs a current loop style Universal
DBox or a TS1000 DBox, disconnect the Gilbarco
console/controller from the distribution box and connect the
Gilbarco style RLM adapter cable (PIE 9000 15 0027) to the
Gilbarco DBox. Plug the long end of the adapter cable into the
RLM DB9P connector on the end of the RLM. Reference
Diagram: RLM-G to Gilbarco later in this section.
2. If the Gilbarco system employs a PA01330000 DBox, cut off the
‘T’ end of the RLM adapter cable (PIE 9000 15 0027). Refer to
Diagram: RLM-G to Gilbarco DBox PA01330000.