Watlow CLS User Manual

Page 27

Advertising
background image

Installation

CLS User’s Guide 19

4.

Place the TB-50 where you will mount it and use a pencil to trace
around the standoffs.

5.

Drill and tap #6-32 holes in the locations you marked.

6.

Place the TB-50 where you will mount it. Insert the #6 screws in the
standoffs and tighten them.

NOTE

Save the cable tie wraps, ribbon cable, and ribbon cable
clamps. You’ll use them when you wire outputs to the TB-
50 and when you connect the ribbon cable.

WARNING

Do not connect power to the CLS now. Test the unit first, as
explained in the Power Wiring and Controller Test section.

Advertising
See also other documents in the category Watlow Sensors: