Watlow CLS - Manual (Page 71)

Setup
CLS User’s Guide 63
Set up Global Parameters Menu
The Set up Global Parameters menu looks like this:
Below is the setup global parameters menu tree. Notice the default
values inside the boxes.:
LOOP PROCESS UNITS
ALARM SETPOINT STATUS OUT%
SETUP GLOBAL
PARAMETERS ?
Setup Global Parameters?
Load setup from job? 1
Save setup to job? 1
Job select dig inputs?
NONE
Job sel dig ins active?
LOW
Output override dig
input? NONE
Override dig in active?
LOW
Startup alarm delay?
0 MINS
Keyboard lock status?
OFF
Power up output status?
OFF
Controller address? 1
Communications
baud rate? 9600
Communications
protocol? ANA
Communications err
check? BCC
AC line freq.?
60 HERTZ
Dig out polarity on alarm?
LOW
EPROM information