Watlow CLS - Manual (Page 69)

CLS User’s Guide 61
Setup
The Setup menus let you change the CLS detailed configuration
information.
If you have not set up a CLS before, or if you don't know what values to
enter, please read first the Tuning and Control section, which contains
PID tuning constants and useful starting values.
How to Enter the Setup Menus?
1. In Single Loop Display, select the loop you wish to edit.
2. While still in Single Loop Display, enter the pass sequence below:
Press Enter, Alarm Ack, Change Setpoint.
3. The first setup menu appears.
NOTE
For your protection, CLS reverts to Single Loop Display If
you don't make any changes for three minutes.
How to edit a menu?
• Press Yes to select this menu or No to advance to the next menu.
• press Yes or No to toggle between the options in your menu.
• Press Enter to store the value you have selected.
• If you decide not to edit the menu, press Back to stop editing and
return to the main menu.
Each display contains the default value for that specific menu, and
below each display you will see the range of choices for that menu.
The following sections tell more about the submenus for each of the six
main menus. If you have a CLS with the Ramp/Soak option, there will
also be a Ramp/Soak menu. (Please refer to the Ramp/Soak
documentation included with your CLS for use instructions.)
The next page shows the setup menus accessible from Single Loop
Display.