Nexo LS18 - Manual (Page 32)

Page 32/103 GEO S12 HARDWARE SETUP PROCEDURE
8.2.2 WARNINGS ON GEO S12 ACCESSORIES
WARNING 1
All GEO S12 & LS18 Accessories are specifically rated in agreement with structural
computations.
Never use other accessories
– including push-pins - when assembling GEO S12 & LS18
cabinets than the ones provided by NEXO: NEXO will decline responsibility over the
entire GEO S12 & lS18 accessory range if any component is purchased from different
supplier.
WARNING 2
For SAFETY reasons, following first generation accessories:
- GEOS12-XBOW
- GEOS12-TCBRK
- GEOS12-SSBRK
- GEOS12-PSBRK
- GEOS12-TTC
Have been recalled in August 2007 and MUST NO LONGER BE USED
These accessories have been replaced by:
- GPT-XBOW-V2
- GPT-TCBRK-V2
- GPT-SSBRK-V2
- GPT-PSBRK-V2
- GPT-TTC-V2
Please contact your local distributor if any doubt in relation the GEO S12 & LS18
accessories you are using.
WARNING 3
All GEO S12 accessories have been designed so that cabinets are arrayed in the
acoustic coupling plane (adjacent waveguides as shown in figures below).
GEO S12 a ssemblies in the “non-coupling plane” – as shown in figure below- are
UNSAFE and STRICTLY PROHIBITED.
YES YES NO